Section 5 Functions and Operations
● Bank No.
(Bits 0 to 2)
● Run/Stop
● Auto / Manual
5-30
• The bank number is specified by the event input ON/OFF state. The
content of the event input is reflected in "Bank No." (Adjustment level).
• This setting data is an operation command that is particular to a
single channel.
• Operation is as follows based on the event input ON/OFF state.
Event input
Bank No.
Bank No.
(Bit 0)
(Bit 1)
OFF
OFF
ON
OFF
OFF
ON
ON
ON
OFF
OFF
ON
OFF
OFF
ON
ON
ON
• To use eight banks (Banks 0 to 7), 3 event input points are required.
• When the event input is ON, operation is stopped and the "STOP"
indicator lights up. The content of the event input is reflected in
"Run/Stop" (Run level).
• This setting data is an operation command that is particular to a
single channel.
• Operation is as follows based on the event input ON/OFF state.
Event input
OFF
ON
• When the event input is ON, the mode switches to manual and the
"MANU" operation indicator lights up. The content of the event input
is reflected in "Auto / Manual" (Run level).
• This setting data is an operation command that is particular to a
single channel.
• Operation is as follows based on the event input ON/OFF state.
Event input
OFF
ON
Description
Bank No.
(Bit 2)
OFF
Run Bank No.0
OFF
Run Bank No.1
OFF
Run Bank No.2
OFF
Run Bank No.3
ON
Run Bank No.4
ON
Run Bank No.5
ON
Run Bank No.6
ON
Run Bank No.7
Description
Run
Stop
Description
Auto
Manual