Omron E5AR - MANUAL 2 User Manual page 247

Section 8 Setting data
Setting
Reference
Reference
CH
Forward/reverse operation
Function
Setting
Reference
Reference
CH
Closed/Floating
Function
Setting
Reference
Reference
8-44
Setting range
0: Standard
1: Heating/cooling
2: Remote SP standard
3: Remote SP heating/cooling
4: Proportional
5: Cascade standard
6: Cascade heating/cooling
The setting range is 0 to 1 on a single- or 4-input type, or 0 to 6 on a 2-
input type.
● Related information
"Section 3 Typical Control Examples" (P. 3-1)
"4.6 Selecting the control mode" (P.4-13)
● Related setting data
"Manual reset value" (Adjustment level) (P.8-15)
"Hysteresis (heat)", "Hysteresis (cool)" (Adjustment level) (P.8-16)
"Control/Transfer output
(P.8-46)
orev
• When direct action is selected, the MV is increased when the PV
increases. When reverse action is selected, the MV is increased
when the PV decreases.
Setting range
or-r: Reverse operation
or-d: Direct operation
● Related information
"4.7 Setting output parameters ■ Direct operation (cool) / Reverse
operation (heat)" (P.4-14)
clfl
• Use this setting to select the control method for a position propor-
tional type.
Setting range
float: Floating
close: Closed
● Related information
"3.3 Position proportional control of a ceramic kiln" (P.3-9)
Units Default value
0
assignment" (Control initial setting 2 level)
Units Default value
or-r: Reverse action
Position proportional type
Units Default value
float: Floating
l.1
l.1