Omron E5AR - MANUAL 2 User Manual page 210

Setting
Reference
Reference
CH
PV/SP (Display 1)
PV/SP (Display 2)
PV/SP (Display 3)
Function
• Standard type
Control method
Standard
Heating/cooling
*1 "Manual output method" (Expansion control setting level) selects
the MV that is used when manual mode is entered. The MV prior to
entering manual mode can be held, or the manual MV default value
can be used.
• Position proportional type
Control method
Position
proportional
● Related setting data
"Auto/Manual" (Operation level) (P.8-11)
"PF1 setting", "PF2 setting" (Advanced function setting level) (P.8-68)
"Manual output method", "Manual MV default value" (Expansion
control setting level) (P.8-77)
• Display 1 shows the PV and Display 2 shows the SP. The SP can be
set.
• Either the local SP or the remote SP is shown depending on the
selected SP mode. In the case of remote SP, the value can only be
monitored.
Local SP mode
SUB1 SUB2 SUB3 SUB4 Present value
3.8.8 (PV)
8
SP
1.5.6.0
MV monitor
9.5.0
CMW MANU
"RSP" goes off
OUT1 OUT2 OUT3 OUT4 STOP RSP
• When using a bank in local SP mode, a link is created to the local SP
of the selected bank. For example, if Bank 3 is selected, the local SP
of Bank 3 appears in Display 2, and when the value is changed, the
value of "Bank 3 local SP" (Bank setting level) also changes.
8.3 Operation level ( )
Setting range Units
-5.0 to 105.0 %
-105.0 to 105.0 %
Monitor range
-10.0 to 110.0
Remote SP mode
SUB1 SUB2 SUB3 SUB4
3.8.8
8
1.5.6.0
9.5.0
CMW MANU
OUT1 OUT2 OUT3 OUT4 STOP RSP
Default value
*1
*1
Units
%
bnk.*
MV
bnk.*
Present value
(PV)
Monitor only
MV monitor
"RSP" lights up
8-7