Move To Setting Area 1; Move To Protect Level - Omron E5AR - MANUAL 2 User Manual

Section 7 Communication (Modbus)

■ Move to setting area 1

Command
Response

■ Move to protect level

Command
Response
7-26
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'07
1 1 2
Use this command to move to setting area 1.
The command is used in setting area 0. Nothing happens if the
command is used in setting area 1.
If the command is used when "Initial setting level protect" is set to "2
(Disable move to input initial setting level)", an operation error will
result.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Slave Function Write start Instruction
address mode address code information
H'06 H'00 H'00 H'07
1 1 2 2
The above indicates a normal end. For information on error responses,
see "7.7 Operation commands (Communication/Modbus)" (P.7-14).
Slave Function Write start Instruction
address mode address code information
H'06 H'00 H'00 H'08
1 1 2 2
Use this command to move to protect level. Protect level is explained
in "4.1 Setting levels and key operation" (P.4-2).
This command is used in setting area 0. If used in setting area 1, an
operation error will result.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'08
1 1 2 2
The above indicates a normal end. For information on error responses,
see "7.7 Operation commands (Communication/Modbus)" (P.7-14).
Related
CRC-16
information
H'00
2 2 bytes
Related
CRC-16
H'00
2 bytes
Related
CRC-16
H'00
2 bytes
Related
information CRC-16
H'00
2 bytes