Omron E5AR - MANUAL 2 User Manual page 193

Section 7 Communication (Modbus)
Response
7-20
Address
H'0600 to 060E
H'0700 to 0744
H'0800 to 0818
H'0900 to 09DE
H'0A00 to 0A8E
H'0B00 to 0B6E
H'0C00 to 0C20
H'0D00 to 0D26
H'0E00 to 0E60
H'0F00 to 0F20
H'1000 to 100E
H'1100 to 110C
H'1200 to 1218
H'1300 to 1332
H'4000 added to above
addresses
H'8000 added to above
addresses
H'C000 added to above
addresses
This command is used to write setting data. The number of elements
can be set from H'0004 to 0068 (4 to 104) to allow successive writing
of 2 to 52 items of setting data in contiguous addresses.
To specify the variable type or address, see "Appendix Setting list"
(P.A-6).
Write setting data to setting area 1 from setting area 1. If written from
setting area 0, an error will result.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
To store setting data of Operation and Adjustment setting levels in
non-volatile memory, select "Backup" with the "Write mode" command.
If not set to "Backup", the setting data will not remain in memory when
the power is turned off. For more information on Operation and
Adjustment levels, see "4.1 Setting levels and key operation" (P.4-2).
Slave Function Write start Number of
address mode address elements
H'10
1 1 2 2
The above indicates a normal end. For information on error responses,
see "7.6 Writing to the variable area" (P.7-12).
Explanation
Ch
Setting data of setting area 0
RUN level
Adjustment level
Adjustment level 2
Bank setting level
PID setting level
Approximation setting level
Setting data of setting area 1
1
Input initial setting level
Control initial setting level
Control initial setting 2 level
Alarm setting level
Display adjustment level
Communications setting level
Special function setting level
Expansion control setting level
2 Same setting data as channel 1
3 Same setting data as channel 1
4 Same setting data as channel 1
CRC-16
2