Section 4 Settings Required for Basic Control
4.1 Setting levels and key operation
The settings are grouped into levels and the set values are called setting data. On the E5AR/ER, the
settings are grouped into 17 levels as shown below.
When the power is turned on, all indicators light up for 1 second. The initial level after power-on is "RUN
level".
Blinks at L + M
250
1
0 0
0 0
L+M
L+M
3 seconds
1 second
or longer
or longer
Protect level
L1 seconds or longer
L1 seconds or longer
4-2
Power on
Adjustment level
Less than
L1 seconds
RUN level
Less than
L1 seconds
Monitor item level
Blinks at L1 seconds or longer
250
1
0 0
0 0
L3 seconds or longer
Control initial
setting level
Less than
L1 seconds
Input initial
setting level
Less than
L1 seconds
Communications
setting level
Password input Set value (in general) -169
Less than
L1 seconds
Special function
Expansion control
setting level
setting level
Less than
L1 seconds
Password input Set value (in general) 1201
Calibration level
Reset from calibration level is by power off.
Adjustment 2 level
Less than
Less than
L1 seconds
L1 seconds
Less than
Less than
L1 seconds
L1 seconds
Approximation
setting level
Control initial
setting 2 level
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Less than
L1 seconds
Display
adjustment level
Control in operation
Control is stopped on all
Control stopped
channels of multi-point input
type.
Bank setting level
Less than
L1 seconds
PID* setting level
Alarm setting level