Omron E5AR - MANUAL 2 User Manual page 314

Output
Operation state
type
31 30 29 28 27 26 25
0
* As follows when read in setting area 1:
• RSP input error
• Potentiometer error
• Display range exceeded
• Input error
• Control output (heating), control output (cooling) : Clear
• Alarm 1, Alarm 2, Alarm 3, Alarm 4
• AT
• Run/Stop
• Auto/Manual
• SP mode, MV tracking
• Control output (heating), control output (cooling) : Update
* Control output (heating) and control output (cooling) are respectively open output and close output
during position proportional control.
* Control output (heating) and control output (cooling) are normally OFF during linear output.
* The control output heating type and/or control output cooling type is off when the corresponding output
is pulse voltage output.
24 23 22 21 20 19 18 17
0 0
16 15 Bit position
0 0
Status
Free
Free
Free
Free
Write mode
EEPROM
Setting area
AT Execute/Cancel
Run/Stop
Write via communication
Auto/Manual
SP mode
MV tracking
Free
Control output
(heat side) type
Control output
(cool side) type
: Clear
: Clear
: Clear
: Clear
: Clear
: Clear
: ON (stop)
: Hold previous value
: Update
Setting list
0 (OFF) 1(ON)
OFF
OFF
OFF
OFF
Backup RAM write
RAM = "EEPROM" RAM "EEPROM"
Setting area 0 Setting area 1
AT stopped AT run in progress
Run Stop
OFF (plohibited) ON (permitted)
Auto Manual
Local SP (LSP) RSP
OFF ON
OFF
Pulse voltage inear current
output output
inear current
Pulse voltage
output
output
A-9