Ram Data Store; Software Reset - Omron E5AR - MANUAL 2 User Manual

Response

■ RAM data store

Command
Response

■ Software reset

Command
Response
7.9 Commands and responses (Communication/Modbus)
Slave Function Write start Instruction
address mode address code information
H'06 H'00 H'00 H'04
1 1 2
The above indicates a normal end. For information on error responses,
see "7.7 Operation commands (Communication/Modbus)" (P.7-14).
Slave Function Write start Instruction
address mode address code information
H'06 H'00 H'00 H'05
1 1 2
This writes the setting data of Operation and Adjustment levels to
internal non-volatile memory. Operation and Adjustment levels are
explained in "4.1 Setting levels and key operation" (P.4-2).
This command can be used in both setting area 0 and setting area 1.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'05
1 1 2
The above indicates a normal end. For information on error responses,
see "7.7 Operation commands (Communication/Modbus)" (P.7-14).
Slave Function Write start Instruction
address mode address code
H'06 H'00 H'00 H'06
1 1 2
A software reset causes the same operation as turning the power off
and on.
This command can be used in both setting area 0 and setting area 1.
To use this command, "Write via communication" must be enabled
using the "Write via communication" operation command.
(No response)
A response is not returned to this operation command.
Related
CRC-16
2 2 bytes
Related
CRC-16
H'00
2 2 bytes
Related
information CRC-16
H'00
2 2 bytes
Related
information CRC-16
H'00
2 2 bytes
7-25