Omron E5AR - MANUAL 2 User Manual page 261

Section 8 Setting data
Auxiliary output 1 non-exciting
Auxiliary output 2 non-exciting
Auxiliary output 3 non-exciting
Auxiliary output 4 non-exciting
Function
Setting
Reference
Reference
8-58
sb1n
sb2n
sb3n
sb4n
• These settings are used to select the output state of alarms 1, 2, 3,
and 4.
• When close in alarm is selected, the state of the alarm output
function is output without change. When
the state of the output function is inverted before output. The relation
between the alarm output function, alarm output, and operation
indicator is shown below.
Auxiliary
Setting data
output function
ON
Close in alarm
OFF
ON
Open in alarm
OFF
Setting data
Auxiliary output 1 non-exciting
Auxiliary output 2 non-exciting
Auxiliary output 3 non-exciting
Auxiliary output 4 non-exciting
● Related setting data
"Bank alarm " (Bank setting level) (P.8-28)
"Bank alarm upper limit
setting level) (P.8-29)
"Auxiliary output assignment" (Control initial setting level 2) (P.8-48)
"Alarm type" (Alarm setting level) (P.8-54)
"Alarm latch" (Alarm setting level) (P.8-55)
"Alarm hysteresis" (Alarm setting level) (P.8-56)
"Standby sequence restart" (Alarm setting level) (P.8-57)
open in alarm
Auxiliary
output
ON
OFF
OFF
ON
Setting range Units
n-o: Close in alarm
n-c: Open in alarm
", "Bank alarm lower limit" (Bank
l.3
is selected,
Operation
indicator
On
Off
On
Off
Default value
n-o: Close
in alarm