Moving The Machine - Ricoh SAVIN D0AP Service Manual

2.2.3 MOVING THE MACHINE

It is dangerous to handle the power cord plug with wet hands. Doing so could result in
•
electric shock.
• Unplug the power cord from the wall outlet before you move the machine. While
moving the machine, take care that the power cord is not damaged under the machine.
Failing to take these precautions could result in fire or electric shock.
• If you have to move the machine when the optional paper tray unit is attached, do not
push on the main unit's top section. Doing so can cause the optional paper tray unit to
detach, possibly resulting in injury.
• When disconnecting the power cord from the wall outlet, always pull the plug, not the
cord. Pulling the cord can damage the power cord. Use of damaged power cords could
result in fire or electric shock.
The machine weighs approximately 19 kg (41.9 lb.). When moving the machine, use
•
the inset grips on both sides, and lift slowly. The machine will break or cause injury if
dropped.
Do not hold the control panel while moving the machine. Doing so may damage the
•
control panel, cause a malfunction, or result in injury.
Be careful when moving the machine. Take the following precautions:
•
Close all covers and trays, including the front cover and bypass tray.
•
• If optional paper feed units are attached, remove them from the machine and move
them separately.
Keep the machine level and carry it carefully, taking care not to jolt or tip it. Rough
•
handling may cause a malfunction or damage the hard disk or memory, resulting in
loss of stored files.
1.
Be sure to check the following:
The main power is turned OFF.
The power cord is unplugged from the wall outlet.
The interface cable is unplugged from the machine.
2.
If optional paper feed units are attached, remove them.
3.
Lift the machine using the inset grips on both sides of the machine. Then move it
horizontally to the place where you want to use it.
Be sure to move the machine horizontally. To prevent toner from scattering, move the
machine slowly.
4.
If you removed the paper feed units, reattach them
SM
Main Machine Installation (P 502/501)
2-11 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1