Fax Connection Unit Error Codes; Error Code - 01; Error Code - 02; Error Code - 03 - Ricoh SAVIN D0AP Service Manual

3.2 FAX CONNECTION UNIT ERROR CODES

3.2.1 ERROR CODE - 01

Error
Code
01(1) IPv4/IPv6 not enabled
01(3) "Cancel" is pressed by user.
01(4) A false connection ID is being used.
01(5) Network disconnected because of no response
within a specified time.
01(14) The machine either of destination or of local is
•
entering SP or Initial setting.
An established connection exists.
•

3.2.2 ERROR CODE - 02

Error
Code
02(5)
• Wrong IP address/hostname is
used
• The machine at destination power
off
LAN cable is disconnected
•
Network is rebooting.
•

3.2.3 ERROR CODE - 03

Error
Code
03
• No user authentication applies for fax
application (i.e.
Basic/Windows/LDAP/Custom Auth.)
Settings other than user authentication
•
are applied to the fax application.
D0C5/D0C6/D0C4/D0AP FAX UNIT
Suggested Cause
Suggested Cause
Suggested Cause
Fax Connection Unit Error Codes
Enable IPv4 and IPv6
-
Check that the network is
established.
•
•
• Enter the correct IP
address/hostname
• Turn on the main power.
• Connect the LAN cable
Wait until the rebooting has finished.
•
Configure the user authentication
setting for client-side and Remote
Machine as the following table.
Client-side Machine
OFF
ON
ON
36
Action
Exit SP or initial setting.
Wait until the connection
has finished.
Action
Action
Remote Machine
OFF
OFF
ON
SM