Ricoh SAVIN D0AP Service Manual page 706

Table of Contents

Printer SP Mode

[Bit Switch]

1-001-011 Bit Switch B Settings

Limitless paper feeding for the bypass tray

When the bypass tray is the target of the "Auto Tray Select", and "Machine

Setting(s): Any Type" is configured for the "Tray Setting Priority" of the bypass

tray, this BitSw can switch the behavior whether or not limitless paper feeding

is applied to the bypass tray.

Enabled (=0: Default):

Limitless paper feeding is applied to the bypass tray.

If a tray other than the bypass tray matches the job's paper size and type but

has run out of paper, printing will occur from the bypass tray.

Disabled (=1):

Limitless paper feeding is not applied to the bypass tray.

If a tray other than the bypass tray matches the job's paper size and type but

has run out of paper, printing will stop and an alert will appear on the LCD

screen, stating that the tray has run out of paper. This prevents unexpected use

of the bypass tray.

Limitations when this BitSw is set to "1":

- Jobs that contain more than one paper size cannot be printed.

- The "Paper Tray Priority: Printer" setting must be configured to a tray other

than the bypass tray.

"Apply Auto Paper Select" to override paper size

or paper type of the device

If this BitSw is enabled, the "Apply Auto Paper Select" setting will decide if the

paper size or paper type that is specified in the device settings should be

overridden by the job's commands when "Tray Setting Priority" is set to

"Driver/Command" or "Machine Setting(s): Any Type".

- Apply Auto Paper Select = OFF: Overridden (priority is given to the job's

- Apply Auto Paper Select = ON: NOT overridden (priority is given to the device

D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1

Chapters

Table of Contents