Ricoh SAVIN D0AP Service Manual page 345

functions can be used.
22. Check that the fax and scanner icons are displayed, and then input the following SP
settings according to the notes taken in Step 6.
SP5-895-001 (Application invalidation: Printer)
•
SP5-895-002 (Application invalidation: Scanner)
•
23. If the security functions (e.g. Stored file encryption/ Auto Erase Memory Setting) were
applied, set the functions again.
24. Ask the customer to restore their address book or restore the address book data using
SP5-846-052 (UCS Setting: Restore All Addr Book), and then ask the customer to ensure
the address book data has been restored properly.
If you obtained the backup of the customer's address book data in step 3, delete the
backup immediately after the NVRAM replacement to avoid accidentally removing
customer information from the work site.
25. Output all the SMC data with SP5-990-001 and make sure all the SP/UP settings, except
counter information, are properly restored by checking the factory setting sheet from Step 1
and the SMC Report from Step 2.
The counters will be reset.
26. Make sure that the "Reception Settings" and "Send Settings" correspond with the notes
taken in Step 8. Correct the settings if they are wrong.
27. Power cycle the machine.
If SP5-824-001 (NVRAM Data Upload) and SP5-825-001 (NVRAM Data Download) cannot be
executed for some reason, enter all data on the SMC Report manually.
If the message "SD card for restoration is required." appears after the NVRAM replacement,
restore the encryption key.
SM 4-141 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
Electrical Components