Ricoh SAVIN D0AP Service Manual page 702

Printer SP Mode
bit 6 Bypass tray paper direction
Changes the paper direction used with "Machine Setting(s): Any Type" in the
bypass tray. This setting enables the direction of the paper in the bypass tray
to specified.
bit 7 DFU
1001 [Bit Switch]
1-001-005 Bit Switch 5 Settings
bit 0 DFU
bit 1 Number of copies with
paper mismatch
If a paper size or type mismatch occurs during the printing of multiple copies,
only a single copy is output by default. Using this BitSw, the device can be
configured to print all copies even if a paper mismatch occurs.
bit 2 GPS filter
If the GPS Filter is disabled, SDK applications will not be able to alter the
print data standard printer applications receive.
Note: The main purpose of this BitSw is for troubleshooting the effects of
SDK applications on data.
bit 3 PS trigger for PDL
switching
Specifying the auto detection algorithm for PS while switching the print
language.
If the Pattern1 is selected, "%%" is used as a printer system PS trigger.
bit 4 Increase Max. number of
the stored jobs.
Changes the maximum number of jobs that can be stored on the HDD. The
default (disabled) is 100. If this is enabled, the max. will be raised to 750 or
1000 depending on the model.
bit 5 DFU
bit 6 Change imposition
specification
This setting enables the specification for imposition such as page alignment
and image rotation to be changed to the specification of old models when job
orientation and paper size are mixed.
The old models are below:
- PCL: 04A and earlier models
- PS/PDF/RPCS: 05S and earlier models
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
LEF
-
0
-
Print Single Copy
Enabled
Standard pattern
Disabled (100)
-
Standard
specification
3-10
SEF
-
1
-
Print All Copies
Disabled
Pattern1
Enabled (750)
-
Old model
specification
SM