Ricoh SAVIN D0AP Service Manual page 454

Rev. 04/02/2020
SC No. Type
5.
6.
SC No. Type
SC112-00 D LED illumination adjustment error: rear side
The white level peak reached the prescribed threshold when the scanning
guide plate was scanned after a specified number of adjustments.
•
•
•
•
•
Power cycle the machine to see if the error reoccurs. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power off/on
after each step.
1.
2.
3.
4.
5.
6.
SC No. Type
SC120-00 D Scanner home position error 1
The scanner HP sensor (S12) did not go OFF :
•
•
•
•
•
•
•
•
Power cycle the machine to see if the error reoccurs. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power off/on
after each step.
1.
2.
3.
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
Error Name/Error Condition/Major Cause/Solution
Replace the FFC (SPDF CIS unit to SCB).
Replace the SCB.
Error Name/Error Condition/Major Cause/Solution
Loose, broken, or defective connector
SPDF CIS unit defective
Harness defective
Scanning guide plate is dirty or defective
Engine board defective
Clean and replace the scanning guide plate on the rear side.
Reconnect the FFC connectors (SPDF CIS unit to SCB)
Clean and replace the scanning guide plate.
Replace the SPDF CIS unit.
Replace the FFC (SPDF CIS unit to SCB).
Replace the SCB.
Error Name/Error Condition/Major Cause/Solution
During homing operation (power ON, leaving low power mode)
During auto adjustment (power ON, leaving low power mode)
During document, book scanning
Scanner motor (M5) drive PCB error
Scanner motor (M5) defective
Scanner HP sensor (S12) defective
Harness defective
Timing belt, pulley, wire, or carriage not installed correctly
Replace the scanner HP sensor (S12).
Replace the scanner motor (M5).
Replace the harness.
6-8
Service Call
SM