Ricoh SAVIN D0AP Service Manual page 429

5.10.3 IMPORTING DEVICE INFORMATION
Import device information saved on an SD card.
1.
Insert an SD card into the media slot on the side of the control panel.
2.
Enter SP mode.
3.
Press SP5-749-101(Import/Export: Import)
4.
Select a unique setting.
5.
Press [Encryption Key], if the encryption key was created when the file was exported.
6.
Select an encryption setting.
Unique If you want to apply the unique information to the target
machine, select the "Unique" key.
Encryption If an encrypted file is selected as the import file, this
setting is required.
7.
Press [Execute].
8.
Press [OK].
If data export fails, the details of the error can be viewed in the log.
•
5.10.4 POSSIBLE SOLUTIONS FOR IMPORT/EXPORT PROBLEMS
The access log file is created when export/import is executed. The file is stored in the same
location as the exported device setting information file.
If an error occurs, check the log's result code in the access log file first. Values other than 0
indicate that an error occurred.
The result code will appear in the circled area illustrated below.
- Example of a log file
If you cannot solve the problem or do not know how to solve it after checking the code, note
down the error log entry, then contact your supervisor.
SM 5-55 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
SP Data Import/Export
Refer to the above
information.