Ricoh SAVIN D0AP Service Manual page 495

SC No. Type
SC855-01 B Wireless LAN board error (driver attachment failure)
Wireless LAN board error (wireless LAN card: 802.11 is covered)
•
•
1.
2.
SC No. Type
SC857-00 B USB I/F Error
The USB interface is unusable because of a driver error.
USB driver error (There are three causes of USB error: RX error/CRC
error/STALL. SC is issued only in the case of STALL.)
1.
2.
SC No. Type
SC860-00 B HDD startup error at power on (HDD error)
•
•
•
•
•
SM
Error Name/Error Condition/Major Cause/Solution
Defective wireless LAN board
Loose connection
Power cycle the machine.
Replace wireless LAN board.
Error Name/Error Condition/Major Cause/Solution
Check the USB connection.
Replace the controller board (Printer: Controller board, MF: SCB).
Error Name/Error Condition/Major Cause/Solution
The HDD is connected but the driver detected the following errors.
• SS_NO.T_READY: (-2): HDD does not become READY
SS_BAD_LABEL: (-4): Partition type incorrect
•
SS_READ_ERROR: (-5): Error occurred while reading or checking
•
the label
• SS_WRITE_ERROR: (-6): Error occurred while writing or checking
the label
SS_FS_ERROR: (-7): Failed to repair the filesystem
•
• SS_MOUNT_ERROR: (-8): Failed to mount the filesystem
SS_COMMAND_ERROR: (-9): Drive not responding to the
•
command
• SS_KERNEL_ERROR: (-10): Internal kernel error
• SS_SIZE_ERROR: (-11): Drive size too small
SS_NO._PARTITION:(-12): The specified partition does not exist
•
SS_NO._FILE: (-13): Device file does not exist
•
Attempted to acquire HDD status through the driver but there has been
no response for 300 seconds or more.
Unformatted HDD
Label data corrupted
HDD defective
6-49 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
Service Call