Ricoh SAVIN D0AP Service Manual page 944

Code Meaning
waiting for a V.21 signal.
0-80 The line was disconnected due to a
timeout in V.34 phase 2 – line
probing.
0-81 The line was disconnected due to a
timeout in V.34 phase 3 – equalizer
training.
0-82 The line was disconnected due to a
timeout in the V.34 phase 4 – control
channel start-up.
0-83 The line was disconnected due to a
timeout in the V.34 control channel
restart sequence.
0-84 The line was disconnected due to
abnormal signaling in V.34 phase 4 –
control channel start-up.
0-85 The line was disconnected due to
abnormal signaling in V.34 control
channel restart.
0-86 The line was disconnected because
the other terminal requested a data
rate using MPh that was not
available in the currently selected
symbol rate.
0-87 The control channel started after an
unsuccessful primary channel.
0-88 The line was disconnected because
PPR was transmitted/received 9
(default) times within the same ECM
SM
Suggested Cause/Action
• If this error occurs, the called terminal falls
back to T.30 mode.
• The guard timer expired while starting these
phases. Serious noise, narrow bandwidth, or
low signal level can cause these errors.
If these errors happen at the transmitting terminal:
• Try making a call at a later time.
Try using V.17 or a slower modem using
•
dedicated tx parameters.
• Try increasing the tx level.
• Try adjusting the tx cable equalizer setting.
If these errors happen at the receiving terminal:
Try adjusting the rx cable equalizer setting.
•
• Try increasing the tx level.
Try using V.17 or a slower modem if the same
•
error is frequent when receiving from multiple
senders.
The signal did not stop within 10 s.
•
Turn off the machine, then turn it back on.
•
If the same error is frequent, replace the
•
FCU.
The signal did not stop within 10 s.
•
• Turn off the machine, then turn it back on.
• If the same error is frequent, replace the
FCU.
• The other terminal was incompatible.
• Ask the other party to contact the
manufacturer.
The receiving terminal restarted the control
•
channel because data reception in the
primary channel was not successful.
This does not result in an error
•
communication.
Try using a lower data rate at the start.
•
Try adjusting the cable equalizer setting.
•
23 D0C5/D0C6/D0C4/D0AP FAX UNIT
Error Codes