Ricoh SAVIN D0AP Service Manual page 938

The FFC connector has the lock lever [A], so tilt the lever to lock the FFC.
18. Turn the main power ON.
19. The SRAM data transfer begins. Transfer is complete when a beep sounds.
The volume of the beeping is set to the same level as the speaker volume.
•
If the speaker volume is set to off, the volume of the beeping is set to its initial
•
factory-set level.
• If the machine does not beep, turn the main power OFF and then ON, and attempt
data transfer again. Try several times if necessary.
Be sure to check the transfer result after executing data transfer. If the transfer
•
has failed, you need to specify settings manually in the SP mode.
20. When "Ready" is displayed on the control panel, turn the power OFF, and remove the AC
power plug from the receptacle.
21. Disconnect the FFC from both FCU boards, and then remove the old FCU board with the
bracket.
22. Reattach the covers.
23. Turn the main power ON.
24. Enter the SP mode.
25. Print the system parameter list from SP6-101 in the Fax SP menu, and then check the list
to see whether the SRAM data has been transferred correctly.
26. Set the correct date and time from the [User Tools].
User Tools > Machine Features > System Settings > Timer Setting > Set Date/Time
If any of the SRAM data was not transferred, input those settings manually.
SM 17 D0C5/D0C6/D0C4/D0AP FAX UNIT
FCU Board