Ricoh SAVIN D0AP Service Manual page 342

Rev. 04/02/2020
Refer to the following destination list.
•
1: Japan
2: North America
3: Europe
4: Taiwan
5: Asia
6: China
7: Korea
11. Power cycle the machine.
If the SCB serial number is not entered correctly, SC995-01 (serial number entry error) will
occur.
12. Copy the data from the SD card to the new NVRAM with SP5-825-001.
13. Turn the main power OFF.
14. Remove the SD card from SD Card Slot 2 (lower slot).
15. Turn the main power ON.
16. Check the factory settings sheet from step 1 and the SMC data printout from step 2, and
then set the user tool and SP settings so they are the same as before.
Controller NVRAM Replacement
1.
Make sure you have the SMC Report (factory settings).
2.
Print out the SMC report (all data) with SP5-990-001.
3.
Turn the main power OFF.
4.
Install an SD card into SD Card Slot 2 (lower slot).
5.
Turn the main power ON.
6.
Copy the NVRAM data to an SD card with SP5-824-001.
Note the following SP settings. They will not be automatically uploaded to the SD card.
These settings will be input manually.
• SP5-895-001 (Application invalidation: Printer)
0: Valid, 1: Invalid
• SP5-895-002 (Application invalidation: Scanner)
0: Valid, 1: Invalid
SP5-985-001 (Device Setting: On Board NIC)
•
0: Invalid, 1: Valid
SP5-985-002 (Device Setting: On Board USB)
•
0: Invalid, 1: Valid
7.
Make sure the customer has a backup of their address book data. If they do not, do the
following procedure to create a backup.
1. Insert an SD card into SD slot 2, and then turn the main power ON.
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1 4-138
Electrical Components
SM