Ricoh SAVIN D0AP Service Manual page 504

Table of Contents

D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1

Error Name/Error Condition/Major Cause/Solution

Update the firmware if the more recent firmware was released.

Error Name/Error Condition/Major Cause/Solution

Delete all error (Delete data area) : Read error

Delete all error (Delete data area) : Write error

Delete all error (Delete data area) : No response from HDD

Delete all error (Delete data area) : Error in Kernel

Delete all error (Delete data area) : No designated partition

Delete all error (Delete data area) : No device file

Delete all error (Delete data area) : Start option error

Delete all error (Delete data area) : No designated sector number

Delete all error (Delete data area) : failure in performing hdd erase

Delete all error (Delete data area) : Other fatal errors

Delete all error (Delete data area) : End by cancellation

Delete all error (Delete data area) : Library error

Delete all error (Delete data area) : Unavailable

Delete all error (Delete data area) : Erasing not finished

Delete all error (Delete data area) : HDD format failure (Normal)

Delete all error (Delete data area) : HDD format failure (Abnormal)

Delete all error (Delete data area) : Unauthorized library

Delete all error (Delete data area) : other errors

An error occurred while data was being erased on HDD or NVRAM

Error detected in HDD data delete the program

Error detected in NVRAM data delete the program

The "Delete All" option was not set

Turn the main power switch off and back on, and then execute "Erase

All Memory" under UP mode again. (However, if there is a defective

sector or other problem with the hard disk, the error will persist even

after trying the above.)

If the "Delete All" option is not installed when this error occurs, install

Service Call

Chapters

Table of Contents