Ricoh SAVIN D0AP Service Manual page 704

Printer SP Mode
7
1001 [Bit Switch]
1-001-009 Bit Switch 9 Settings
bit 0 PDL Auto Detection timeout of jobs
submitted via USB or Parallel Port
(IEEE 1284).
To be used if PDL auto-detection fails. A failure of PDL autodetection doesn't
necessarily mean that the job can't be printed. This bit switch tells the device
whether to time-out immediately (default) upon failure or to wait 10 seconds.
bit 1 DFU
bit 2 Job cancel after jam
This setting enables it to be specifed whether jobs will be cancelled after a
jam occurs.
Note: If this BitSw is enabled, printing under the following conditions might
result in problems:
- Job submission via USB or Parallel Port
- Spool printing (WIM > Configuration > Device Settings > System)
- Printing a large number of jobs continuously (The status of the job are not
acquired when jobs exceeding the number guaranteed by the job monitor are
continuously printed.)
bit 3 DFU
bit 4 Timing of the PJL Status ReadBack
(JOB END) when printing multiple
collated copies.
This BitSw determines the timing of the PJL STATUS JOB END sent when
multiple collated copies are being printed.
Mode 0: JOB END is sent by the device to the client after the first copy has
completed printing. This causes the page counter to be incremented after the
first copy and then again at the end of the job.
Mode 1: JOB END is sent by the device to the client after the last copy has
finished printing. This causes the page counter to be incremented at the end
of each job.
bit 5 UTF-8 mode
Enabled (=0): Text composed of UTF-8 characters can be displayed in the
operation panel.
Disabled (=1): UTF-8 characters cannot be displayed in the operation panel.
For example, job names are sometimes stored in the MIB using UTF-8
encoded characters. When these are displayed on the operation panel, they
D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
0
Disabled
(Immediately)
-
Not cancelled
-
Mode 0
Enabled
3-12
1
Enabled (10
seconds)
-
Cancelled
-
Mode 1
Disabled
SM