Ricoh SAVIN D0AP Service Manual page 487

Table of Contents

Operation panel Flair communication error (Smart Operation Panel)

The Smart Operation Panel is communicating with the main machine (this is

called "flair communication"), and there was no response from the main

This SC is detected when the controller cannot respond to the notification

from the monitoring service module (operation panel).

Device ID is not identified (toner cartridge): Device ID error (Incorrect ID)

Device ID is not identified (toner cartridge): Channel error

Device ID is not identified (toner cartridge): Device ID error (No ID chip)

Device ID is not identified (toner cartridge): Communication error

Device ID is not identified (toner cartridge): Communication timeout

Device ID is not identified (toner cartridge): The device has stopped its

Device ID is not identified (toner cartridge): The device has stopped its

Device ID is not identified (toner cartridge): The device has stopped its

Device ID is not identified (toner cartridge): The device has stopped its

Device ID is not identified (toner cartridge): The requested buffer is full

Device ID is not identified (toner cartridge): SRAM OPEN: Verification error

An error is notified during the ID identification after three retries.

Power cycle the machine to see if the error reoccurs. If the SC occurs again,

do the following steps. Check if the SC reoccurs by cycling the power off/on

after each step.

Error Name/Error Condition/Major Cause/Solution

Power cycle the machine.

Replace the SCB.

Error Name/Error Condition/Major Cause/Solution

ID tag contact failure

Check if there are dirty or abnormality on the ID chip connector. If you can

see the dirty or abnormality, clean or replace the ID chip connector.

Reconnect the connectors between the engine board (Printer: BCU, MF:

SCB) and ID chip connector.

Replace the toner cartridge.

D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1

Service Call

Chapters

Table of Contents