Ricoh SAVIN D0AP Service Manual page 941

Code
0-15 The other terminal is not capable of
specific functions.
0-16 CFR or FTT not detected after
modem training in confidential or
transfer mode
0-17 Communication was interrupted by
pressing the stop key
0-20 Facsimile data not received within 6
s of retraining
0-21 EOL signal (end-of-line) from the
other end not received within 5 s of
the previous EOL signal
D0C5/D0C6/D0C4/D0AP FAX UNIT
Meaning Suggested Cause/Action
• Try adjusting the tx level and/or cable
equalizer settings.
Replace the FCU.
•
Cross-reference
See error code 0-08.
•
The other terminal is not capable of accepting the
following functions, or the other terminal's memory
is full.
Confidential rx
•
Transfer function
•
SEP/SUB/PWD/SID
•
• Check the line connection.
• Replace the FCU.
Try adjusting the tx level and/or cable
•
equalizer settings.
The other end may have disconnected, or it
•
may be defective; try calling another
machine.
If the rx signal level is too low, there may be a
•
line problem.
Cross-reference
• See error code 0-08.
If the Stop key was not pressed and this error
•
keeps occurring, replace the operation panel
or the operation panel drive board.
Check the line connection.
•
Replace the FCU.
•
Check for line problems.
•
• Try calling another fax machine.
• Try adjusting the reconstruction time for the
first line and/or rx cable equalizer setting.
Cross-reference
Reconstruction time - G3 Switch 0A, bit 6
•
Rx cable equalizer - G3 Switch 07 (PSTN)
•
Check the connections between the FCU and
•
the line.
Check for line noise or other line problems.
•
• Replace the FCU.
20
Error Codes
SM