Ricoh SAVIN D0AP Service Manual page 461

SC No. Type
SP2-931-003)
•
•
•
Power cycle the machine to see if the error reoccurs. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power off/on
after each step.
1.
2.
3.
4.
SC No. Type
SC396-01 D Drum motor (M3) error
The motor LOCK signal is detected for more than 2 seconds while the motor
START signal is ON.
•
•
•
•
Power cycle the machine to see if the error reoccurs. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power off/on
after each step.
1.
2.
3.
4.
5.
SC396-02 D Drum motor (M3) error (When the motor is deactivated)
The motor LOCK signal is not detected for more than 2 seconds while the
motor START signal is OFF
•
•
•
Power cycle the machine to see if the error reoccurs. If the SC occurs again,
do the following steps. Check if the SC reoccurs by cycling the power off/on
after each step.
1.
SM
Error Name/Error Condition/Major Cause/Solution
Connector defective (disconnected, loose) or harness defective
Toner end sensor (S9) defective (no light emission)
Dirty detection surface of the toner cartridge
Check and clean the detection surface of the toner cartridge.
Reconnect the toner end sensor (S9) connector.
Re-install the PCDU.
Replace the PCDU.
Error Name/Error Condition/Major Cause/Solution
Drum motor (M3) defective
Loose, broken, defective connector or harness defective
Engine board (Printer: BCU, MF: SCB) defective
PCDU overload
Replace the drum motor (M3).
Reconnect the drum motor (M3) connector.
Replace the drum motor (M3) harness.
Replace the engine board.
Replace the PCDU.
Drum motor (M3) defective
Harness defective
Engine board (Printer: BCU, MF: SCB) defective
Replace the drum motor (M3).
6-15 D0AP/D0C4/D0C5/D0C6/M0BQ/M0D1
Service Call