Ricoh SAVIN D0AP Service Manual page 986

No Function
0 Subject for Delivery TX/Memory Transfer
This setting determines whether the RTI/CSI registered on this machine or the RTI/CSI of
the originator is used in the subject lines of transferred documents.
0: Puts the RTI/CSI of the originator in the Subject line. If this is used, either the RTI or CSI
is used. Only one of these can be received for use in the subject line.
1: Puts the RTI/CSI registered on this machine in the Subject line.
When this switch is used to transfer and deliver mail to a PC, the information in the Subject
line that indicates where the transmission originated can be used to determine automatically
the destination folder for each e-mail.
1 Subject corresponding to mail post database
0: Standard subject
1: Mail post database subject
The standard subject is replaced by the mail post database subject in the following three
cases:
1) When the service technician sets the service (software) switch.
2) When memory sending or delivery specified by F code is applied by the SMTP server
3) With relay broadcasting (1st stage without the Schmidt 4 function).
This switch does not apply for condition 3) when the RX system is set up for
•
memory sending, delivery by F-code, sending with SMTP RX and when operators
are using FOL (to prevent problems when receiving transmissions).
2-7 Not Used (do not change these settings)
I-fax Switch 05 (SP No. 1-102-006)
No Function
0 Mail Addresses of SMTP Broadcast Recipients
Determines whether the e-mail addresses of the destinations that receive transmissions
broadcasted using SMTP protocol are recorded in the Journal.
For example:
"1st destination + Total number of destinations: 9" in the Journal indicates a broadcast to 9
destinations.
0: Not recorded
1: Recorded
1 IFAXTX Retries
Determines whether the machine retries sending IFAX when connection and transmission
fails due to errors.
0: Disabled
1: Enabled
SM
Comments
Comments
65 D0C5/D0C6/D0C4/D0AP FAX UNIT
Bit Switches – 2