Chapter 3 Specifications; General Specifications - Mitsubishi Electric NZ2GFSS2 32D S1 User Manual

3
SPECIFICATIONS
This chapter describes the general specifications, performance specifications of each module, and function list.
3.1

General Specifications

Item Specifications
Operating ambient 0 to 55
temperature
Storage ambient -40 to 75
temperature
Operating ambient 5 to 95%RH, non-condensing
humidity
Storage ambient humidity 5 to 95%RH, non-condensing
Vibration resistance Compliant with JIS B 3502
and IEC 61131-2
Shock resistance Compliant with JIS B 3502 and IEC 61131-2 (147m/, Operation time: 11ms, 3 times each in X, Y, and Z directions with sine half-
wave pulses)
Operating atmosphere No corrosive gases, flammable gases, less conductive dust
*1
Operating altitude 0 to 2000m
Installation location Inside a control panel
*2
 or less
Overvoltage category
*3
Pollution degree 2 or less
Equipment class Class 
*1 Do not use or store the module under pressure higher than the atmospheric pressure of altitude 0m. Doing so may cause malfunction.
When using the module under pressure, please consult your local Mitsubishi representative.
*2 This indicates the section of the power supply to which the equipment is assumed to be connected between the public electrical power
distribution network and the machinery within premises. Category  applies to equipment for which electrical power is supplied from
fixed facilities. The surge voltage withstand level for up to the rated voltage of 300V is 2500V.
*3 This index indicates the degree to which conductive material is generated in terms of the environment in which the equipment is used.
Pollution degree 2 is when only non-conductive pollution occurs. A temporary conductivity caused by condensing must be expected
occasionally.
*4 When the module is used at altitude above 2000m, the withstand voltage performance and the upper limit of the operating ambient
temperature decrease. Please consult your local Mitsubishi representative.

Under intermittent
vibration
Under continuous
vibration
*4
Frequency Constant
acceleration

5 to 8.4Hz
8.4 to 150Hz 9.8m/

5 to 8.4Hz
8.4 to 150Hz 4.9m/
Half amplitude Number of sweeps
3.5mm 10 times each in X,
Y, and Z directions


1.75mm

3 SPECIFICATIONS
3.1 General Specifications
3
19