Mitsubishi Electric NZ2GFSS2 32D S1 User Manual page 190

■Input dark test execution setting
Set whether to perform the input dark test function of the diagnostic function in the safety remote I/O module.
Address Name
(hexadecimal)
0150H Input dark test execution setting
b15 b14 b13
0 (fixed)
When "0: Not used" is selected in the wiring selection of input, this parameter will be ignored.
The following table lists the combinations that can be set when the wiring selection of input is set to "1: Double wiring (NC/
NC)".
Input dark test
execution setting
Xn: Perform
Xn+1: Perform
n: An address assigned to the master station by the station number settings.
■Input dark test pulse OFF time
Set the width of the OFF pulses that the test pulse output terminals output.
Address Name
(hexadecimal)
0152H Input dark test pulse OFF time
When "0: Not used" is selected in the wiring selection of input for all points, or "1: Do not perform" is selected
in the input dark test execution setting for all points, this parameter will be ignored.
■Number of pulse output for input dark test
Set the number of pulse output for input dark test.
Address Name
(hexadecimal)
0153H Number of pulse output for input dark test
When "0: Not used" is selected in the wiring selection of input for all points, or "1: Do not perform" is selected
in the input dark test execution setting for all points, this parameter will be ignored.
APPX
188
Appendix 4 Remote Buffer Memory
b12 b11 b10 b9
Xn+1: Perform
Xn+1: Do not perform
Xn: Perform
Xn: Do not perform
Setting range
0: Perform
1: Do not perform
b8 b7 b6 b5
X7 X6 X5
Setting range
0: 400s
1: 1ms
2: 2ms
Setting range
0: 1 time
1: 2 times
2: 3 times
b4 b3 b2
X4 X3 X2
Wiring selection of input
Double wiring (NC/NC)
Can be set.
Cannot be set.
Can be set.
Cannot be set.
Default value
0000H
b1 b0
X1 X0
Default value
0000H
Default value
0000H