Mitsubishi Electric NZ2GFSS2 32D S1 User Manual page 145

Error code Safety error subset code
(hexadecimal)
Error
classification
0530H 450
0580H 450
0582H 450
0590H 450
0591H 450
Classification
Error item
number
(hexadecimal)
0530H Moderate error
Recoverable
0580H Moderate error
Recoverable
0582H Moderate error
Recoverable
0590H Moderate error
Recoverable
0591H Moderate error
Recoverable
Error name Description and
cause
Parameter data An incorrect value
error (input dark or parameter (input
test execution dark test execution
setting) setting) out of the
range is set.
Parameter data An incorrect value
error (module or parameter data
identification (module
code) identification code)
out of the range is
set.
Parameter data An incorrect value
error (wiring or parameter (wiring
selection of selection of output)
output) out of the range is
set.
Parameter data An incorrect value
error (output or parameter
dark test (output dark test
execution execution setting)
setting) out of the range is
set.
Parameter data An incorrect value
error (output or parameter
dark test pulse (output dark test
OFF time pulse OFF time
setting) setting) out of the
range is set.
Action
• Correct the module parameter
settings (input dark test
execution setting) and module
configuration.
• When "Wiring selection of input"
Xn (n: even number) is set to "1:
Double wiring (NC/NC)", set the
same value for Xn+1.
• When the parameters are set
again and the parameter setting
has succeeded, the module will
recover from this error.
• Correct the module parameter
setting and module
configuration.
• Check that the actual
configuration matches with the
module configuration set in the
"Network Configuration Settings"
of engineering tool.
• When the parameter is set again
and the parameter setting has
succeeded, the module will
recover from this error.
• Correct the module parameter
settings (wiring selection of
output) and module
configuration.
• When "Wiring selection of
output" Yn (n: even number) is
set to "1: Double wiring (Source/
Source)", set the same value for
Yn+1.
• When the parameters are set
again and the parameter setting
has succeeded, the module will
recover from this error.
• Correct the module parameter
settings (output dark test
execution setting) and module
configuration.
• When "Wiring selection of
output" Yn (n: even number) is
set to "1: Double wiring (Source/
Source)", set the same value for
Yn+1.
• When the parameters are set
again and the parameter setting
has succeeded, the module will
recover from this error.
• Correct the module parameter
settings (output dark test pulse
OFF time setting) and module
configuration.
• When "Wiring selection of
output" Yn (n: even number) is
set to "1: Double wiring (Source/
Source)", set the same value for
Yn+1.
• When the parameters are set
again and the parameter setting
has succeeded, the module will
recover from this error.
10 TROUBLESHOOTING
143
10.7 List of Error Codes
10