Mitsubishi Electric NZ2GFSS2 32D S1 User Manual page 189

■Double input discrepancy detection type
Set the detection type of the double input discrepancy.
Address Name
(hexadecimal)
0131H Double input discrepancy detection type
b15 b14 b13 b12
0 (fixed)
The following describes the setting range of the parameter.
• Discrepancy detection time specified: The discrepancy detection time setting is required in the "Double input discrepancy
detection time" parameter.
• Discrepancy detection time not specified: The discrepancy detection time setting is not required in the "Double input
discrepancy detection time" parameter. The double input discrepancy is detected not by the elapsed time after the
discrepancy has occurred, but after the double input status turns on from the discrepancy state and remains on for 500ms.
When "0: Not used" or "2: Single wiring" is selected in the wiring selection of input, or "1: Do not detect" is
selected in the double input discrepancy detection setting, this parameter will be ignored.
■Double input discrepancy auto recovery setting
Set whether to use or not the auto recovery at double input discrepancy detection error.
Address Name
(hexadecimal)
0132H Double input discrepancy auto recovery setting
When "0: Not used" or "2: Single wiring" is selected in the wiring selection of input for all points, or "0: Do not
detect" is selected in the double input discrepancy detection setting for all points, the double input discrepancy
detection error does not occur and the automatic recovery is not performed.
■Double input discrepancy detection time
Set the double input discrepancy detection time.
Address Name
(hexadecimal)
0140H to 0143H Double input discrepancy detection time
When "0: Not used" or "2: Single wiring" is selected in the wiring selection of input, "1: Do not detect" is
selected in the double input discrepancy detection setting, or "1: Discrepancy detection time not specified" is
selected in the double input discrepancy detection type, this parameter will be ignored.
b11 b10 b9 b8
Setting range
0: Discrepancy detection time specified
1: Discrepancy detection time not specified
b7 b6 b5 b4
Setting range
0: Not used
1: Used
Setting range
1 to 6000 (10ms)
Appendix 4 Remote Buffer Memory
Default value
0000H
b3 b2 b1 b0
X6 X4 X2 X0
X7 X5 X3 X1
Default value
0000H
Default value
1 (10ms)
APPX
187
A