Replacing A Dimm Module In T1600 Routing Engines; Removing A T1600 Dimm Module - Juniper T1600 Hardware Manual

T1600 Core Router Hardware Guide

Replacing a DIMM Module in T1600 Routing Engines

220
Figure 121: Installing an LCC-CB
Removing a T1600 DIMM Module on page 220
1.
Installing a T1600 DIMM Module on page 221
2.

Removing a T1600 DIMM Module

The DIMM modules are located on the top of the Routing Engine. To remove a DIMM
module:
Place an electrostatic bag or antistatic mat on a flat, stable surface.
1.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect
2.
the strap to one of the ESD points on the chassis.
Remove the Routing Engine.
3.
Depending on which Routing Engine you are using, there are two different procedures
4.
for ejecting the DIMMs:
For Routing Engines with an ejector on one side of the DIMM, press the plastic ejector
of the DIMM module. The edge of the module raises upward.
For Routing Engines with ejectors on each side of the DIMM, press the plastic ejectors
on both sides of the DIMM module.
Grasp the DIMM module, being careful not to touch any electrical components on the
5.
module, and firmly pull it out of the slot on the Routing Engine.
Copyright © 2010, Juniper Networks, Inc.