Installing The M320 Chassis In The Rack Manually; Figure 48: Attaching The Installation Handle - Juniper M320 Hardware Manual

Installing the M320 Chassis in the Rack Manually

Copyright © 2015, Juniper Networks, Inc.
CAUTION: If you are installing two routers in one rack, install the lower one
first. Installing a router in the upper position in a rack or cabinet requires a lift.
CAUTION: Before front-mounting the router in a rack, have a qualified
technician verify that the rack is strong enough to support the router's weight
and is adequately supported at the installation site.
Lifting the chassis and mounting it in a rack requires three people. The empty
chassis weighs approximately 142 lb (64.7 kg).
To install the chassis in the rack (see
Ensure that the rack is in its permanent location and is secured to the building. Ensure
1.
that the installation site allows adequate clearance for both airflow and maintenance.
For details, see "M320 Site Preparation Checklist Requirements" on page
Attach the installation handle by tightening the captive screws of the handle into the
2.
holes previously occupied by the captive screws of the power supplies in slots
and PEM3 (see Figure 48 on page
screwdriver, number 2.

Figure 48: Attaching the Installation Handle

Position the router in front of the rack or cabinet, centering it in front of the mounting
3.
shelves. Use a pallet jack if one is available.
With one person on each side and one person in the front, hold onto the bottom of
4.
the chassis and carefully lift it onto the large and small (if installed) mounting shelves.
Chapter 18: Installing the M320 Without a Mechanical Lift
Figure 49 on page 153):
151). Tighten the screws, using a Phillips (+)
85.
PEM1
151