Nortel DMS 100 Series Maintenance Manual page 232

6-80 RSC-M card replacement procedures
NTMX82
in an RSC-M
(continued)
4
5
297-8223-550 Standard 04.02 November 2000
RCO2 SysB
0 Quit PM
2 Post_ RCO2
3 ListSet
4 RCO2 0 ISTb
5 TRNSL Unit0:
6 TST Unit1:
7 BSY
8 RTS
9 OffL
10 LoadPM_
11 Disp_
12 Next_
To determine the location of the RCO2 main or extension half shelf (left or
right) with the circuit card to replace, type
>QUERYPM
and press the Enter key.
Example of a MAP display:
PM Type: RCO2 PM No.: 0 PM Int. No.: 9 Node_No: 24
PMs Equipped: 53 Loadname:KRI07BI1 EEPRom Load:MX77MNG03
WARM SWACT is supported and available
RCO2 0 is included in the REX schedule.
REX on RCO2 0 has not been performed.
Node Status: {OK, FALSE}
Unit 0 Act, Status: {OK, FALSE}
Unit 1 Inact, Status: {OK, FALSE}
Site Flr RPos Bay_id Shf Description Slot EqPEC
RSC-M 00 C02 RSC-M 00
RSC-M 00 C02 RSC-M 00
To display defective C-side links, type
>TRNSL C
and press the Enter key.
Example of a MAP response:
LINK 0 PLGC 0
LINK 1 PLGC 0
LINK 2 PLGC 0
LINK 3 PLGC 0
LINK 4 PLGC 0
LINK 5 PLGC 0
If C-side links
are defective
ManB OffL
0 0 2
0 0 0
Links_OOS: CSide
Inact ISTb
Act InSv
05 RCO2: 000
47 EXT:LEFT
0;CAP MS:STATUS OK
1;CAP S:STATUS SBsy
2;CAP MS:STATUS OK
3;CAP S:STATUS OK
4;CAP S:STATUS OK
5;CAP S:STATUS SBsy
Do
step 7
CBsy ISTb InSv
0 2 25
0 1
1, PSide 1
MX85AA
01:13 MX86AA
MSGCOND OPN
MSGCOND OPN
1