Nt6X92 In An Rsc-M - Nortel DMS 100 Series Maintenance Manual

Application
Use this procedure to replace an NT6X92 circuit card in a Remote Switching
Center Multi-access (RSC-M) main shelf.
Note: In the examples of this section, RSC-M refers to RCO2. When
software outputs messages to the MAP terminal, the software does not
differentiate between the two types of RCO2.
For maximum performance, do not install the UTR and GTR on the
same RSC-M RC02. Currently there is no way to determine which
receiver is used to interpret tones. Some call processing tones can be
degraded if the tones are designed for use with a GTR.
PEC
NT6X92
NT6X92
Common procedures
This section refers to the following procedures:
•
•
Action
This procedure contains a summary flowchart and a list of steps. Use the
flowchart to review the procedure. Follow the steps to perform the procedure.
DMS-100 Family Remote Switching Center Multi-Access Maintenance Manual XPM11 and up
Suffixes
CA
EA
replacing a card
returning a card
RSC-M card replacement procedures 6-19
ATTENTION
Name
Universal tone receiver card (UTR)
Global tone receiver card (GTR)
NT6X92
in an RSC-M