Nortel DMS 100 Series Maintenance Manual page 156

6-4 RSC-M card replacement procedures
NT6X69
in an RSC-M
(continued)
To Replace a/an NT6X69 in an RSC-M
At your Current Location:
1
2
At the MAP terminal
3
297-8223-550 Standard 04.02 November 2000
Continue with this procedure if:
• a step in a maintenance procedure directs you to this card
• you use this procedure to verify or accept cards
• your maintenance support group directs you to this procedure.
WARNING
Loss of service
When you replace a card in the RSC-M, make sure that the
unit in which you replace the card is inactive and the mate
unit is active.
Obtain a replacement card. Make sure the replacement card has the same
PEC and PEC suffix, as the card to be removed.
Make sure the peripheral module (PM) level of the MAP display appears,
type:
>MAPCI;MTC;PM;POST RCO2 rco2_no
and press the Enter key.
where
rco2_no
is the number of the rco2 with the defective card
Example of a MAP display: