Nortel DMS 100 Series Maintenance Manual page 129

25 To return the link to service, type
>RTS link link_no
and press the Enter key.
where
Note: Perform this step for each link that was made busy.
26 To post the inactive RCO2, type
>post RCO2 rco2_no
and press the Enter key.
where
Note: This RCO2 must be SysB.
27 To return the inactive PM unit to service, type
>RTS PM
and press the Enter key.
If RTS for both RCO2 units
passes
fails
28 To manually busy the inactive RCO2 unit, type
>bsy unit unit_no
and press the Enter key.
where
29 To perform an out of service (OOS) test on the inactive RCO2 unit, type
>tst unit unit_no
and press the Enter key.
where
If TST
passes
DMS-100 Family Remote Switching Center Multi-Access Maintenance Manual XPM11 and up
link_no
is the number of the link identified in step 17
rco2_no
is the number of the RCO2 identified in step 2
unit_no
is the number of the inactive RCO2 unit from step 26
unit_no
is the number of the RCO2 unit made manually busy in step 28
RSC-M alarm clearing procedures
PM RSC-M/RCO2
critical
Do
step 37
step 28
Do
step 30
5-19
(continued)