12
Seat and lock the card.
a
b
13
Refer to the following table to determine the next step:
If you enter this procedure from
alarm clearing procedure
other
14
To reset the inactive RCO2 unit, type:
>PMRESET UNIT unit_no
DMS-100 Family Remote Switching Center Multi-Access Maintenance Manual XPM11 and up
Use your fingers or thumbs to push on the upper and lower edges of the
faceplate. Peform this action to make sure the card is fully seated in the
shelf.
Close the locking levers.
RSC-M card replacement procedures
in an RSC-M
Do
step 19
step 14
6-47
NTMX74
(continued)