A&D Omniace III RA2300A Instruction Manual page 94

12. X-Y Recorder
(5) Print Icon
Pressing this icon executes the printout for the X-Y monitor currently displayed. The following
table illustrates the X-Y printing status during X-Y recording.
Normal
(6) File Icon
Pressing this icon button sets file recording to ON or OFF. Setting to ON saves data of X-Y
recording in internal HDD file. The data saved can be displayed in the X-Y graph on the replay
monitor. Moreover, operating status is indicated during X-Y recording. The File icons that
appear are as follows.
ＯＮ
File save destination during X-Y recording is a folder in the internal HDD. The file name is
NOTE
created based on the time that starts recording.
Example: D:\RA2300XY\XY041201.fsd
(7) X-Y Recorder Control Block
a) Sampling rate
b) Grid
a） Sampling rate
This button is used to set data sampling rate for X-Y recording.
b） Grid
This button is used to set grid to ON or OFF in the X-Y monitoring and X-Y printing. For grid
pattern for the X-Y printing, see 16. System Setup.
c） Temporary stop
The X-Y monitoring can be stopped temporarily. Pressing this button again cancel this
temporarily stop.
d） Clear
This button is used to clear the waveforms on the X-Y monitor.
e） Y-axis scale
This button is used to switch the Y-axis scale representation.
f） Data interpolation
X-Y waveform data interpolation can be set.
To execute
To execute
ＯＦＦ
c) Temporary stop
d) Clear
12-4
Error
Error
e) Y-axis scale
f) Data interp
olation
RA2300A Recorder (7001754-R01)