Connector/Pin Location; Event Box (Ra23-146); Overview And Features; Built-In And Connection - A&D Omniace III RA2300A Instruction Manual

Table of Contents

This event box is the unit for check of both voltage input level (H level and L level) and contact input level

(H: Short and L: Open).

The event box (RA23-146) comprises following elements:

1) Event box I/F (RA23-327)

2) Event box (RA23-328)

3) Cable (0311-5257)

The event box I/F (RA23-327) is inserted into event slot of RA2300A, and then the event box I/F

(RA23-327) is connected to the event box (RA23-328) by using the cable (0311-5257)

● Built-in to RA2300A

Please power off RA2300A. and then remove power cable. Please remove panel of event slot as shown

below, and insert event box I/F along the slot, and finally fix the event box I/F with screws.

● Connection Event box I/F with Event box

Please connect Event box I/F with Event box using Cable (0311-5257)

WARNING

Please do the abovementioned both built-in and connection operations after power off and removing

power cable. There is a possibility of failure unless power off and removing power cable.

17.4.3.Connector/Pin Location

(As seen from the inserting side of the plug)

RA2300A Recorder (7001754-R01)

17-9

17. How to Use Optional Units

Table of Contents