Screen Operation - A&D Omniace III RA2300A Instruction Manual

8.1. Screen Operation

Open the following screen by pressing one button among Input Signal, Amp, Recording Condition, and
Trigger buttons in the Pen Recorder mode.
(1) Waveform display block
(1) Waveform display block
Input signals are displayed in this block. The basic functions are almost same as the Input
Monitor. The signal monitoring speed in this block is the same as the chart feed speed.
For more details,
(2) Amp setup block
This block is used to set amp unit. For more details,
(3) Chart feed speed
These buttons are used to set chart recording paper feed speed. Value is set by pressing a
button. Through User 1 and User 2 buttons, user can set arbitrary feed speeds.
For more details,
(4) Annotation printing
ON/OFF for annotation printing can be set.
For more details, see
RA2300A Recorder (7001754-R01)
8. Pen Recorder (Recording Low-speed Signal for Long Time)
(3) Chart feed speed
see Chapter 5. Observing Input Signal.
Chapter 16 System Setup
16. System Setup.
8-3
(4) Annotation printing
(2) Amp setup block
see Chapter 7. Amp Units