Rs-232C Unit (Ra23-142:Optional); Ac Bridge Power Supply Unit (Ra23-143:Optional) - A&D Omniace III RA2300A Instruction Manual

20. Specifications

20.10.RS-232C Unit (RA23-142:Optional)

Function Access host computer, control OMNIACE by commands.
JIS X5101 (formerly C6361)compliance
Data type
Transmission
Speed
Transmission
Specification
Mode
Start Bit
Data Bit
Stop Bit
Parity Bit
D Sub-Connector 9 Pin
Connector
Mass Approx. 50g
Pin
Configuration

20.11. AC Bridge Power Supply Unit (RA23-143:Optional)

Function Bridge Power for 2CH AC Strain amp unit (AP11-104/104A)
2Vrms､Sinusoidal Wave 5kHz
Birdge Power
With synchronization ternimals, synchronyzation with RA2300A included in other
Acbridge power supply units is availeble.
Synchronization
With master/slave switch
※ Synchronization with RT3424ST is available; Be careful of connector contact..
Mass Approx. 60g
Notes1) 2CH AC strain amp unit (AP11-104/104A) need including into the main unit to use.
20.12.English Display Unit (RA23-155: Optional, specified at
ordering)
Function Operation Panel, display, recorded contents are written in English.
Instruction Three different instruction manuals are written in English.
Manual
Bit Serial
38400, 19200, 9600, 4800, and 2400[bps]
Start-Stop Transmission, Full-duplex transmission
1[bit]
7,8[bit]
1,2[bit]
Without parity bit, EVEN, ODD
Pin No Signal
1 CD(Carrier Detect)
2 RD ( Received Data )
3
SD(Transmitted Data)
4
ER(Data Terminal Ready)
5 SG ( Signal GND)
Pin No Signal
6 DR ( Data set Ready )
7 RS(Request to Send)
8
CS ( Clear to Send )
9
RＩ(Ring Indicator)
20-16
RA2300A Recorder (7001754-R01)