Right-Side Block - A&D Omniace III RA2300A Instruction Manual

2. Name and Function of Each Block

2.4. Right-side Block

Up to eight optional amps can be installed in this block.
(1)
(2)
(3)
(4)
(5)
(This is an example that installs eight 2CH High-Speed DC Amp Units)
(1) Faceplate
Power voltage input range and power dissipation is indicated.
(2) Power switch
This switch turns on or off this recorder.
(3) AC socket
AC power cable is connected to the socket.
(4) TRIG IN
This terminal is used to enter an external trigger signal when input signal level is not used
as a trigger source.
(5) TRIG OUT
This terminal is used to synchronously operate other instruments by outputting trigger signal.
Additionally, signal from this terminal is used to monitor the status of the trigger.
(6) LAN
This is a connector for LAN connection.. This connector is useful when a communication
between personal computers is made.
(7) USB
This is a USB connector. Memory devices such as USB memory or external drives can be
connected.
(8) AC bridge power switch (INT/EXT)/OSC terminal
This is INT/EXT switch for AC bridge power unit (RA23-143, optional) and OSC terminal.
INT, the instrument that is connected to the OSC terminal should be set to EXT. In either
NOTE
case, wrong settings may prevent the recorder from correct measurement and cause
failure.
minal should be set to EXT. In either case, wrong settings may prevent the recorder from
correct measurement and cause failure.
(9) Input block
Up to optional eight amps can be installed.
(7)
(8)
(6)
2-6
(9)
RA2300A (7001754-R01)