Amp Details Screen - A&D Omniace III RA2300A Instruction Manual

7.1.2. Amp Details Screen

The Amp Details screen appears when the Channel button is pressed on the Amp Basic screen.
Detailed channel settings can be made. The following screen is a screen for 2CH High-Resolution
DC Amp (AP11-101).
(1) Channel
Channel to be set up is selected. Pressing a button changes the contents of (6) Detailed setup
block..
(2) Extra Event
Detailed settings for Event Unit (RA23-145) are made. Pressing a button changes the contents
of (6) Detailed setup block.
If the optional Event Unit (RA23-145) is not installed, setup cannot be made.
NOTE
(3) Batch
Batch setting for the same type of amp can be made. Pressing the button highlights this button,
indicating the batch setup is effective. In addition, the Channel buttons of target channels of
batch setup highlight, too. If specific channels should setup through batch setup, cancel the
highlight of the channels by pressing the Channel button that will not be set. To set through the
batch setup, highlight the target channels again.
Only the same type of units can be set through the batch setup.
NOTE
(4) Input setup
ON, OFF, and GND for input is set. GND may not be provided depending on the amp. If the
input is set to OFF, neither waveform nor digital values are displayed.
(5) Detailed settings
Contents differ depending on the amp type. Refer to the description of each amp type.
RA2300A Recorder (7001754-R01)
7-3
7. Amp Units
(1)Channel
(2) Extra Event
(3) Batch
(4) Input setting
(5)Detailed setup block