Overview Of X-Y Recorder Mode - A&D Omniace III RA2300A Instruction Manual

12. X-Y Recorder

12.1. Overview of X-Y Recorder Mode

The X-Y Recorder mode is a mode that is specialized to real-time X-Y printing, which outputs X-Y
waveforms on chart paper. Data sample speed and amp settings are available on a screen.
To set the recorder to the X-Y recorder mode, use the Measurement Mode tab on the System screen.
In addition, the measurement mode settings can be made on the Startup screen that is displayed when
the recorder is started up. (* The Startup screen may not be displayed depending on the settings.)
Measurement
mode selection
Operation Panel
Setup completes after
the mode turns to yellow
after execution
Since the X-Y Recorder is a mode that is specialized to the X-Y printing, the same screen
NOTE
is displayed even screen buttons of Input Signal, Amp, Recording Condition, and Trigger.
Pressing Close closes the Setup screen.
The mode setting completes after the
screen is switched.
12-2
Press OK.
RA2300A Recorder (7001754-R01)