Explanation Of Setting Keys - A&D Omniace III RA2300A Instruction Manual

4. Operation Flow (Flow of Measurement, Basic Settings and Operations)
(1) Control block
This block is always displayed on the top of the screen and is used for setting function and
switching the screen. The contents of the control block change in accordance with a measurement
mode and a setting item being selected. Refer to various measurement modes of Chapters 8-12 for
details about control block.
(2) Setting block
To display a setting screen on this block, press the [Amp], [Store condition], and [Trigger] button on
the operation panel. Refer to description of various measurement modes of [Chapter 8 Amp Unit],
[Chapter 13 Trigger Settings], and [Chapters 8-12] for details about operation on a setting screen.
(3) Waveform monitor block
Because the input waveform monitor is always displayed on the normal setting screen, settings can
be made while observing the input signals.

4.2.2. Explanation of setting keys

Each setting item displays a different image depending on the input method to be used. The various
input methods are explained below.
● Jog key
When the jog dial image is displayed in the setting block, the jog dial on the operation panel
can make settings. Use the jog dial to change the setting value of the item that is highlighted
(active).
● Window key
"Hand" icon displayed on the key indicates that a window will open upon selection. Settings
can be made in this newly opened window.
● Jog key + "HAND" icon
In this case, the operation is a combination of the above two items. When the blank of the
setting block is selected, the key operates as the jog dial (item highlighted), and when the icon
is selected, a setting window will open.
Normal
Active (settable)
4-4
RA2300A Recorder (7001754-R01)