Start Of Measurement; To Finish Measurement (Forced Termination); Waveform Chart Printing; Upon Error Generation - A&D Omniace III RA2300A Instruction Manual

Table of Contents

10.3. Recording Operation

Pressing the Start button on the operation panel starts HD recording. While recording is made,

pressing the Stop button forcibly stops the recording.

10.3.1. Start of Measurement

Pressing the Start button on the operation panel starts HD recording. If the setup in which the start

of recording is initiated with a trigger signal, the start of recording is made with a trigger detection.

If the combination of recording speed, recording length, data type, and recording channel

NOTE

count is not covered by recorder specifications, recording cannot be made and operation

finishes with an error.

For HD recording, see 10.4 HD Recording Specifications.

Pressing the Stop button on the Operation Panel executes forced termination. If recording length is

specified, operation completes when specified number is recorded.

During HD recording, waveform chart printing is started and stopped as necessary. Moreover,

chart feed speed can be changed.

For operation, see 10.2Recording Condition Setup.

Errors may be generated and operation during HD recording

Generated error

File error

Paper-out error

RA2300A Recorder (7001754-R01)

Operation

HD recording finishes with an error. If waveform chart printing

operates, operation continues.

HD recording continues. Waveform chart printing finishes with an

error. Printing is restarted after the chart paper is filled.

10-7

10. HD Recorder (Recording data in the internal HDD)

Table of Contents