Overview Of Pen Recorder Mode - A&D Omniace III RA2300A Instruction Manual

8. Pen Recorder (Recording Low-speed Signal for Long Time)

8.1 Overview of Pen Recorder Mode

The Pen Recorder mode offers a pen recorder function, which is dedicated to waveform printing. Chart
feed speed and amp settings are made on a screen, which are exactly equivalent to the operability of a
pen recorder.
To set the recorder main unit to the Pen Recorder mode, use Measurement Mode tab in the System
screen. Measurement mode setting is made on the Startup screen that is displayed upon the startup.
(Depending on the startup screen, the Startup screen may not be displayed.)
Operation panel
Setup completes after the
mode turns to yellow after
execution.
As the Pen Recorder mode only performs waveform printing on a chart recording paper, Even
NOTE
the Input Signal, Amp, Recording Condition, and Trigger buttons are pressed, the screen
display does not change.
Measurement
mode
selection
System screen
Pressing Close closes the Setup screen. The
mode setting completes after the screen is
switched.
8-2
Press OK
RA2300A Recorder (7001754-R01)