A&D Omniace III RA2300A Instruction Manual page 42

4. Operation Flow (Flow of Measurement, Basic Settings and Operations)
4.1. Operation Flow
This recorder records, stores, and replays input signals, following the procedures described below.
(1) Before power application
Confirm that this recorder has been set in a safe place, and that all the accessories are properly
attached.
Refer to Chapter 3 for details.
(2) Applying power
● Inputting signals to the amp units.
Note that applying a voltage greater than the maximum allowable input voltage specified by
the sensitivity setting of each amplifier unit may cause damage to the main unit or internal
components.
Refer to AMP Unit Instruction Manual for details.
● Confirming the status of the signals
Input signals can be monitored in real-time.
Refer to Chapter 5 for details.
(3) Settings
● Amplifier unit settings
Set the conditions for the data to be recorded.
Refer to Chapter 7 for details.
● Trigger settings
Set the trigger for activating to be recorded.
Refer to Chapter 13 for details.
● Measurement mode settings
Select the mode appropriate for the kind of object desired from the 5 available measurement
modes.
・To print the recording chart paper
Refer to Chapter 8 for details.
・To store high-speed events in memory
Refer to Chapter 9 for details.
・To store and record events over a long time in HDD
Refer to Chapter 10 for details.
・To store events quickly during low-speed signal recording
Refer to Chapter 11 for details.
・To use as X-Y recorder
Refer to Chapter 12 for details.
(4) Measurement
Start measurement with the [START] key on the operation panel.
Stop measurement with the [STOP] key on the operation panel.
(5) Replay
Display stored data
Refer to Chapter 14 for details.
Copy stored data on the recording paper or save a file of the data
Refer to Chapter 14 for details.
Pen recorder mode
Memory recorder mode
HD recorder mode
Multi-recorder mode
X-Y recorder mode
Replay settings
Output selection
4-2
RA2300A Recorder (7001754-R01)