Stop Due To Error - A&D Omniace III RA2300A Instruction Manual

(3) Marking
Marking is printed by pressing the Marking button on the Operation Panel during recording..
Marking time is also printed after ↓Ｍ.
Example: ↓M17:06:20 2004/11/29
(4) Signal name
Character strings set by user by channel are printed. The position of printing is near the zero
level of each signal. If the annotation printing position overlaps with a signal waveform, the
annotation is printed at above or below the waveform. If annotation cannot be printed within in
the waveform printing range, the annotation printing is omitted.
For printing ON/OFF for signal name and character string settings,
System Setup.
(5) Scale
Analog waveform amplitude scale is printed. Printing OFF and scale printing format can be
changed with settings.
For details of scale settings,
(6) Time axis
Time axis scale is printed below the waveform printing grid. Printing ON, OFF, and format (e.g.
value and time) can be set.
For more details on settings,
(7) Measurement information
Character strings specified by user are printed before waveforms are printed.
To set printing ON, OFF, or character strings,
(8) Page annotation
Following system annotation, character strings defined by user are printed over waveform
printing. To set printing ON, OFF, or character strings,
(9) Channel annotation
Recording condition by signal is printed.

8.2.1. Stop Due to Error

Printing stops in the following cases.
● Chart paper-out
In the case where chart paper run out, printing cannot be made. In this case, printing is
terminated. When red marks at the both sides of the chart recording paper, prepare new chart
recording paper as they signifies paper-out.
● Thermal head over-heating
If the thermal head for printing is heated too much, operation stops due to error. If printing of
entire screen is repeatedly made, the temperature of the thermal head at printing block rises.
In this case, the recorder automatically controls the print density, thereby prohibiting
temperature rise. However, if the ambient temperature is so high or heat release is not made
smoothly, thermal head temperature excessively rises. In such case, printing is terminated due
to error so as to prevent fire breakout.
RA2300A Recorder (7001754-R01)
8. Pen Recorder (Recording Low-speed Signal for Long Time)
see Chapter 16. System Setup.
see Chapter 16. System Setup.
see Chapter 16. System Setup.
8-5
see Chapter 16.
see Chapter 16. System Setup.