Jump; Basic Jump; Time Jump; Address Jump - A&D Omniace III RA2300A Instruction Manual

14.6. Jump

Jump of Y-T waveform display position can be made after the time axis position is specified. Pressing
the Jump button on the upper part of the Replay screen displays the following screen.

14.6.1. Basic Jump

Basic jump operation is made.
Start point:
End point:
Trigger detection point:
Cursor X1/X2:

14.6.2. Time Jump

Jump is made after the waveform display position is specified. Specify the time using the Time tab
on the Jump screen. Pressing the Apply and OK buttons execute a jump.
When the Apply button is pressed, the jump screen does not close the Jump screen even
TIPS
after the jump execution. To execute jump continuously, this button is usable.
If the recording rate of the recording data is external sync, time jump cannot be made
NOTE
because the time axis cannot represent as time. Use [14.6.3Address Jump]

14.6.3. Address Jump

Jump can be made after waveform position is designated in address. Open the Address tab on the
Jump screen, and then specify the address. Press the Apply button and OK button to execute a
jump.
RA2300A Recorder (7001754-R01)
Jump to recording data start point
Jump to the end point of the recording data
Jump to the trigger detection point for recording data
If there is no trigger detection point, jump is made to the start point.
Jump to current cursor position
14-7
14. Replay Display (Displaying Recording Data)
14.6.1Basic Jump
14.6.2Time Jump